1. General introduction
The swimming pool filter acts as the “heart” of the entire swimming pool system. This is a device that helps maintain clean, safe and balanced water quality, minimizes algae and bacteria, and reduces the amount of chemicals used.
Tham khảo thêm: https://saigonpoolspa9.blogspot.com/2025/11/huong-dan-su-dung-van-hanh-may-loc-nuoc-ho-boi.html
Proper operation of swimming pool water filters not only helps keep water clean but also prolongs equipment life, saves energy and ensures stable filtration performance year-round.
Saigonpoolspa – a unit specializing in designing, constructing and installing swimming pool water filtration systems nationwide – shares detailed instructions below to help you operate and care for the filtration system most effectively.
2. Basic structure of swimming pool water filtration system
A typical swimming pool water filtration system consists of the following main components:
Pool pump: Pulls water from the pool through the filter system and pushes clean water back out.
Sand filter (or glass filter): Removes dirt, small debris, hair, leaves and impurities suspended in water.
Multi-function valve (6 functions): Controls operating modes such as filtering, backwashing, draining, forward washing...
Suction and discharge pipes: Carry water into and out of the system.
Pressure gauge: Monitors operating status and when filter sand needs to be cleaned.
👉 Working principle:
Water is pumped from the lake → goes through the filter → impurities are retained in the sand layer or filter material → clean water is returned to the lake.
The continuous cycle keeps the water clear and safe.
3. Instructions for operating a piped water filtration system
3.1. Modes on 6-function valve
Function Mode When in use
Filter Circulates water through the filter tank. Daily use.
Backwash Backwash, clean the filter sand layer When the water is low, the pressure increases
Rinse Rinse, drain remaining dirty water After Backwash
Waste Discharge water directly outside when needing to lower the water level or suck out bottom sediment
Recirculation Water circulation without filter When testing operation or chemical treatment
Close Close the entire system during maintenance and cleaning.
⚠️ Important note:
Always turn off the pump before turning the valve to avoid damaging the seal or cracking the tube.
After each backwash, turn on Rinse for 30–60 seconds to avoid returning cloudy water to the pool.
3.2. The most effective water filtration cycle
To keep your tank clean, maintain a filtration time appropriate to the tank capacity:
Family pond: 5–6 hours/day
Hotel and resort pools: 8–10 hours/day
Backwash the filter: 1–2 times/week or when the pressure increases abnormally.
💡 Tip: Filtering water in the morning or evening helps save electricity, because the temperature is lower and the water circulation is more stable.
4. How to operate a pipeless pool water filter (smart filter)
Pipeless pool filter also known as smart filter, is an all-in-one integrated device: pump, filter tank, suction head and water return head.
4.1. Outstanding advantages
No need to dig pipes, quick installation in 30 minutes.
Space saving, suitable for small ponds and garden ponds.
Easy to disassemble, move, clean quickly and operate smoothly.
4.2. How to use
Place the machine at the edge of the pool, at the specified water level.
Connect the power source, turn on the switch.
Automatic machine to suck - filter - return water.
Clean the filter basket weekly.
Clean the main filter with pressurized water every month.
🔹 Lưu ý: Không đặt máy ở nơi nắng gắt hoặc mưa tạt trực tiếp. Khi không dùng lâu, nên ngắt điện và che phủ máy.
5. Bảo dưỡng và vệ sinh hệ thống lọc nước
5.1. Rửa ngược bình lọc
Khi áp suất tăng hơn 0.3 bar hoặc dòng nước yếu, cần thực hiện:
Tắt máy bơm.
Xoay van sang chế độ Backwash.
Bật máy bơm cho chạy 2–3 phút đến khi nước trong.
Sau đó xoay sang Rinse 1 phút để xả sạch.
5.2. Thay cát lọc đúng thời gian
Cát lọc nên được thay định kỳ 12–24 tháng/lần.
Khi cát bị bão hòa hoặc kết tảng, khả năng lọc giảm, khiến nước đục nhanh.
Quy trình thay cát:
Ngắt nguồn điện.
Tháo van và lấy cát cũ ra.
Rửa sạch bình và ống lọc.
Đổ cát mới theo khuyến nghị của hãng.
Rinse trước khi đưa vào vận hành Filter.
🚫 Không dùng cát xây dựng, vì hạt không đều dễ làm tắc ống hoặc vỡ lưới lọc.
5.3. Kiểm tra hệ thống điện – bơm
Không để máy bơm chạy khô.
Kiểm tra định kỳ phớt, ổ bi và dây tiếp đất.
Đặt máy trong nơi khô ráo, thoáng gió.
6. Những lỗi thường gặp và cách khắc phục nhanh
Vấn đề Nguyên nhân Giải pháp
Nước hồ đục Cát bẩn, lọc yếu Rửa ngược hoặc thay cát
Bơm không hút nước Mực nước thấp, van sai vị trí Kiểm tra mực nước, điều chỉnh van
Áp suất cao Cát nghẹt, rác trong ống Vệ sinh ống và rửa ngược
Máy kêu to Không có nước trong bơm Châm nước mồi trước khi khởi động
7. Lợi ích khi vận hành đúng cách
✅ Giữ nước luôn trong xanh, an toàn cho người bơi.
✅ Giảm tiêu hao hóa chất và điện năng.
✅ Hạn chế hư hỏng đường ống, tăng tuổi thọ máy bơm.
✅ Tiết kiệm chi phí vận hành – bảo trì dài hạn.
✅ Duy trì thẩm mỹ, tăng giá trị công trình hồ bơi.
8. Dịch vụ hỗ trợ chuyên nghiệp từ Saigonpoolspa
Với hơn 15 năm kinh nghiệm, Saigonpoolspa là đơn vị thi công, lắp đặt và bảo dưỡng hệ thống lọc nước hồ bơi hàng đầu Việt Nam.
Chúng tôi cam kết:
Cung cấp thiết bị chính hãng (Emaux, Minder, Astralpool, Kripsol, Waterco...).
Tư vấn kỹ thuật miễn phí, thiết kế theo thể tích hồ và nhu cầu sử dụng.
Bảo dưỡng – thay cát – sửa chữa tận nơi, nhanh chóng và chuyên nghiệp.
Đội ngũ kỹ sư luôn sẵn sàng hỗ trợ 24/7 toàn quốc.
📞 Hotline: 0902 722 748
🌐 Website: https://saigonpoolspa.com
9. Câu hỏi thường gặp (FAQs)
1️⃣ Máy lọc hồ bơi nên chạy bao lâu mỗi ngày?
👉 Nên chạy 5–8 giờ/ngày tùy thể tích hồ. Hồ lớn, nước bẩn nên chạy lâu hơn.
2️⃣ Bao lâu cần thay cát lọc hồ bơi?
👉 Mỗi 12–24 tháng, tùy mức độ sử dụng và áp suất bình lọc.
3️⃣ Khi nào cần rửa ngược (Backwash)?
👉 Khi áp suất tăng trên 0.3 bar hoặc khi nước trả lại hồ yếu hơn bình thường.
4️⃣ Có nên tự thay cát lọc tại nhà?
👉 Có thể, nhưng nếu không quen, nên nhờ kỹ thuật viên Saigonpoolspa để tránh hư hỏng đường ống hoặc tràn nước.
5️⃣ Máy lọc thông minh có cần bảo dưỡng không?
👉 Có. Dù tự động, bạn vẫn nên vệ sinh giỏ rác và lõi lọc mỗi tuần để đảm bảo hiệu quả.
10. Kết luận
Việc sử dụng và vận hành máy lọc nước bể bơi đúng kỹ thuật không chỉ giúp nước trong sạch mà còn đảm bảo thiết bị hoạt động ổn định, tiết kiệm chi phí lâu dài.
Nếu bạn đang cần lắp đặt, bảo trì hoặc tư vấn chọn máy lọc phù hợp, hãy liên hệ ngay Saigonpoolspa – chuyên gia hàng đầu trong lĩnh vực hồ bơi tại Việt Nam.
0コメント